[. . . ] You must not use the CYBEX child seat with a two-point belt or a lap belt. When securing your child with a two-point belt, the child may sustain lethal injuries in an accident. Please note the following for such cases: –– In cars equipped with airbags you should push the passenger seat as far back as possible. Please make sure that the upper point of the vehicle seat belt staysbehind the belt guide of the child seat. [. . . ] The safety cushion should be well adjusted to touch the child‘s chest without exerting any pressure on the child`s body. Safety cushion (p) may only be used in conjunction with the main frame (w) and only up to a mximum weight of 18kg!SITTING AND RECLINING POSITION – ECE GRoup 1 (9 - 18 KG) It is not necessary to open the car belt system (f), to bring the CYBEX child seat into reclining position. €– When the child is about to fall asleep, pull the handle (v) and the seat slides down automatically. €– When the child is no longer in the seat you can move the seat into an upright position by again pulling the handle (v) and slightly pressing against the booster. Make sure that the handle (v) of the reclining mechanism is audibly locked in any position. The reclining position is only approved for ECE Group 1 (9-18 kg), in conjunction with main frame (w) and safety cushion (p)!Make sure that both lap belt and the shoulder belt are always tightly fastened. RECLINING HEAD REST The CYBEX Pallas has a reclining headrest (r) preventing your child‘s head from falling forward when asleep. Furthermore, this adjustable headrest contributes to the comfort of your child during the car ride. Please ensure that the child‘s head always remains in contact with the reclining headrest since otherwise the headrest cannot fulfill its optimal side-crash protective function. By slightly lifting the headrest, the inclination of the headrest (r) can be adjusted in three different positions. In case of an accident, the free movement of the inclination must be guaranteed since otherwise your child might be injured. V a w d q s 13 Fastening of seatbelt with safety cushion attached - ECE group 1 (9-18 kg) 1. Attach the previously adjusted safety cushion to the child seat (see chapter „Safety cushion adjustment“). Take the lap belt (n) and slide it into the dedicated belt routings (x) (marked red) of the safety cushion. Please slide the shoulder belt (f) parallely to the lap belt into the same belt routing (x). Pull the belt (f) tight and make sure that the belts (f) and (n) are running completely inside (over the whole width) of the belt routing (x). Press the release buttons (q) until you can feel some resistance (d) and pull it away from the main frame until you feel a resistance. Now pull the reclining handle (v) situated centrally on the bottom of the booster (d) and completely pull the booster off the frame (w) . For removal of the spacers (s) it is recommended to bring the seat into reclining position. Pull up the backrest cover (a) to reveal the finger hole on the back side of the backrest. [. . . ] To obtain such warranty it is required to take or ship the product to the retailer, who initially sold this product to a customer and to submit an original proof of purchase (sales receipt or invoice) that contains the date of purchase, the name of the retailer and the type designation of this product. This warranty shall not apply in the event that this product is taken or shipped to the manufacturer or any other person other than the retailer who initially sold this product to a consumer. Please check the product with respect to completeness and manufacturing or material defects immediately at the date of purchase or, in the event that the product was purchased in distance selling, immediately after receipt. In case of a defect stop using the product and take or ship it immediately to the retailer who initially sold it. [. . . ]